Eyelash extensions are really trendy these days and the most preferred fashion accessory for nearly every lady. While they are available in three main types- synthetic, silk and mink. The mink lashes are gaining utmost fame. They give you extremely accepted look which are easy to wear and make your eyes look more expressive. Before you start using mink lashes read the following suggestions on how to use and clean your mink lashes.

How to use?

Measure and trim as needed- Initially, you need to use an eyeliner and mascara to your real lash line. Now, cautiously remove the eye-lashes from its dish with the help of tweezers. Make sure you do not tug on the hair.

Measure these lashes right up to your eye in a way that it correctly fits the distance end to end of your lash line. Now cut just as much as would make the lashes a little shorter than your real lash length.

Use lash adhesive- Hold the false lashes with your tweezers and press them gently. Take some adhesive and apply just a thin layer on to the eyelash strip. Allow it to dry for about 30 to 40 seconds or until you find the paste getting sticky.

Apply the lashes and wait- Lean your chin a bit up and use these eyelashes above the real lash line. Keep holding for a little while, about a few seconds, so that the adhesive dries, and then free the lashes from the grip of the tweezers. You have to kindly press the lashes on your lash line.

How to clean?

Once you are back and are about to remove the lashes, do so softly, and then clean them healthy. Cleaning the lashes cautiously extends its lifeline, and therefore must be finished with care. So, let us now discover more about the lashes cleaning process.

Be careful and moderate- Remove them softly, as any added pressure will only harm them. But before you remove them you need to clean your hands. Now, apply a bit makeup remover on to the mink lashes to help loosen the adhesive.

Get rid of the adhesive- Once you have the lashes out you need to get rid of the adhesive from your lash line. This is significant because if not finished correctly it may distress your lash line, in addition, you will find it hard to reapply the fake lashes onto the lash line.

Clean naturally- Getting rid of any adhesive from the fake eyelashes is very essential. You can use your tweezers and let go any stick both from the front and back sides. If required, rub off any remaining glue with the help of your fingernail.

Clean with water- Clean the lash strip, but make sure the water does not reach your mink or 3D lashes tip as that may distress the twist and the lead as well.

Place the 3D lashes in the original box- Once you have cleaned and the lashes have dried out, place them back in their unusual box.