If you wish to install your Netgear wifi range extender and you have a Mac OS X or iOS device then Netgear has this special web address Mywifiext Local for you so that you can easily setup your Netgear wifi range extender without any kind of difficulty or errors. Mywifiext Local is a local web site, which is not like the other ordinary internet sites, where you can setup your Netgear extender on a Mac OS X or iOS device. This site is specially made for setup of your extender via such devices.
Issues While Setting Up Your Extender via Mywifiext Local
Sometimes you might encounter troubles while setting up your Netgear extender via your Mac OS X or iOS on Mywifiext Local. you may see errors like unable to access the Mywifiext Local page, cannot create account on Mywifiext , not able to register your Netgear wifi range extender, cannot find the steps to install the extender or not able to enter the site using the extender’s IP address 192.168.1.250.
You might face these errors because of various reasons. However you can read here as to how to correct those errors of mywifiext local web site. The solutions are listed down below –
• Mywifiext is a local web site and not an ordinary site which is used to access the Netgear Genie/Smart wizard settings
• Your extender might have loose connections or it might not be connected properly wirelessly or through an Ethernet cable
• Follow through the steps on Mywifiext.net website and carefully register your extender
• Make sure you have a good internet service else you will have problems while setting up the extender
• Your browser should be updated to the latest version
Setup with Mywifiext Local
When you have made sure about the above things which might cause errors while setting up your Netgear wifi range extender, you can go forward to carefully configure your extender on the Mywifiext Local web site.If in case you are unable to setup the extender you can call on the toll free number 1-855-777-7456.
1. Plug in your extender in an electrical outlet and switch it on
2. The green power LED lights should light up when you switch it on. If the green power LED doesn’t light up you must switch off and on the extender again
3. You can either connect your device wirelessly or through an Ethernet cable
4. Open a browser and type https://www.my-wifiext.net/ setup
5. Login with the default username and password
6. Select the network that you need to extend
7. Make the required settings
8. When you are done you can go on the finish button and click it in order to finish the setup
Once you are done setting up the extender on your Mac OS X or iOS via Mywifiext local website, you can go on and take the extender around the home or office and place it at a location which is best for it. You will find the best location with the indication of the LED lights on the extender. Red light means there is no wifi signal available there, Amber light indicates good wifi signals and green light shows the wifi signals are perfect in that place. You should place the extender at that location and experience the full benefits of it in all areas.