In the production process of Vertical Mill Coating Mill, there are many failures. In order to reduce its impact on production efficiency, it is necessary to find the causes in time and solve them in a timely manner. One of the common ones is that it suddenly fails to occur during production. This phenomenon is to introduce the cause of this failure and the solution.

The point is to accumulate material at the discharge port. During the White Gray Raymond Mill Price production process of the vertical mill, the lower vertebra body of the cyclone separator, also called the canopy material, is mainly caused by the wet material, or the material is slightly hot and sticky. The unloaded material will be hoarded at the discharge port of the cyclone separator. This kind of scene is very simple to ignore. Only after tapping, the hoarded material can be unloaded. Second, the speed of the vertical mill conditioning profiler and the air volume of the fan The larger the air volume, the coarser the powder will be, and the smaller the air volume, the finer the powder will be. The speed of the parser and the better air volume position will be different depending on the material. Not the same. When conditioning the fineness of a powder, a better fixed speed is: the one that is satisfied with the fineness, drives to a larger air volume, so as to ensure that the powder produced by the vertical mill reaches a greater output when the powder is produced. Inventing greater value for users;

The third point, you can check whether the air duct of the host is blocked, or it is caused by air leakage, and the seal of the cyclone feeder is not tight, and there is a reverse suction scene. These are also the reasons that will affect the discharge problem; The article mainly introduces the causes of the unexpected phenomenon during the production of the vertical mill, and the solutions to these reasons. The analysis of these factors is introduced in detail above.