Double Sided Butyl Tape (1.5" x 100')

Double Sided Butyl Tape (1.5" x 100')

This product is made of a super tacky butyl rubber that sticks well to most masonry surfaces and also polyethylene. Being a two sided tape, this will allow you to mount objects on vertical surfaces and will also create a seal. In some situations it can be used as an alternative to using nails and washers or screws to mechanically fasten the polyethylene liner or rigid foam insulation (such as Bora-Foam). At the same time, it can serve the purpose of sealing the liner or insulation board to the wall and eliminating the need for caulking.To get more news about Double Sided Butyl Tape, you can visit official website.

Directions for attaching polyethylene or Bora-Foam to a wall or pier: First you need to firmly apply the tape to the masonry surface. Then pull the paper backing carefully off by pulling alongside of the wall (as opposed to away from the wall). Finally, apply the top edge of your liner (or foam board) to the face of the tape. You now have fastened the liner (or foam board) to the wall and also created a seal.
Premium 2 mm thick Butyl Tape for waterproofing, airtightness & durability

Excellent initial adhesion – even at low temperatures, to difficult surfaces such as: PE films, rubber, concrete, foams and various metals.
The special PE net carrier provides the tape structural integrity, extra strength & stability.
The extra butyl adhesive thickness allows for improved adhesion & conformability to rough surface areas.
The Butyl is designed for permanent waterproof bonding & fixing, especially suited to sealing applications in roofing, building & joining plastic dam liners

Views: 3


You need to be a member of On Feet Nation to add comments!

Join On Feet Nation

© 2023   Created by PH the vintage.   Powered by

Badges  |  Report an Issue  |  Terms of Service