Furnaces are today a necessity to every homeowner. They are particularly used to keep your home at a comfortable temperature while the weather outside may literally be freezing. As with any home appliance, furnace repair in Manhattan is also required to maintain your home’s heated temperatures.

In case of a gas heating system, one of the most common issue is the leaking problems. Usually, you can smell a gas leak. If you do begin to smell natural gas, it’s important to call in your gas company immediately. If the smell is strong, it is advisable to leave the house both for your own health and to keep you out of danger. Any type of spark could cause drastic consequences.

When the pilot light goes off, you may have one of many problems. The thermocouple may be loose, requiring a technician’s repair. Sometimes the orifice may be clogged. You can actually fix this problem with a thin piece of wire all by yourself. Turn off the gas and shut off the furnace at the circuit breaker first, then stick a thin piece of wire into the tiny hole where the gas comes through to feed the pilot light.

This procedure should remove the debris and ash that is clogging the tube. Eventually, your gas flow may be brought down too low to keep the flame lit. Refer to the your owner’s manual where you will have information on how the flame should look and how to adjust the amount of gas to achieve the perfect flame.

If you are not satisfied with the performance, there are several aspects to check before you call the technician. Check out for the items that presumably thwart the flow of the warm air - perhaps a piece of furniture, a child’s toy bin, a pillow, or other random item. Make sure your thermostat is set properly. You may also raise the temperature about five degrees and see if that kicks the heat on.

Check the room’s heating registers. They may not be opened. Examine the filter, since a dirty filter may obstruct the passage of the air flow. If you find a dirty filter, supplant it with a new one and see if that perks up the heating system. Finally, if all these measures go in vain, it’s time to call a professional expert for furnace repair in Queens.

Sometimes the heating unit may be broken by tripped circuit breaker or even a blow fuse, so if your unit doesn’t seem to be performing at all, there are a number of items you can check. To start with, make sure that the thermostat is set to heat. If it’s been switched to the cooling or off position, it won’t trip the heat on. Check out the circuit breaker or make sure the switches are turned on. Reset the motor if required. If all else fails, it’s time to call your technician.