New customers who have started searching for temperature data loggers to be able to monitor their freezers along with refrigerators often ask, "do you've got a temperature data logger that you could put in your chiller? " Based on each of our past experience with some customers with tried this approach, we recommend that you do not keep the temperature data logger from the refrigerator! This sounds basic, but it's certainly easier than knowing the right way to place a probe in the fridge. However, there are four reasons why you don't want to place the temperature data logger from the refrigerator.
temperature data loggers website
gsp-6-temperature-data-logger

Reducing Transmission
If the "wireless temperature data logger" must be used with WiFi, bluetooth or other types of wireless data, the metal casing on the refrigerator significantly reduces this "wireless" signal. It's like trying to use your phone inside an elevator. Sometimes this works, sometimes it won't. If the fridge incorporates a glass door, a signal can be received. But if cabinets and doors are made of metal, they rely on signals reduce small gaps around the door seals. Typically, this ends up with a significant reduction throughout signal strength, which brings about very limited or intermittent operations.

Reducing Battery Capability
Another important reason is the low temperature in the particular refrigerator can greatly decrease the battery capacity. Usually of thumb, the form of lithium battery most commonly used in temperature data loggers is 50 percent cooler at 0°F. On low temperature, the internal resistance on the battery increases and this output voltage decreases. Simply speaking, this can lead that will frequent battery changes. Some customers utilize the popular "USB Logger" brand, which complains of less than a month of battery life. These loggers are surprising simply because they typically run for half a dozen to nine months on some batteries. It was later discovered how the recorder had been placed directly within a refrigerator operating at 0°F.

Delaying Display
If the device has an LCD and would need to read data or alarm information in the display, it can always be difficult at low temp. The standard LCDS employed in most low-cost temperature data loggers are intended to run at temperatures as much as 32 degrees Fahrenheit. When the temperature drops, the present responds very slowly, so the data for the screen may no longer manage to be updated. Usually, the monitor just isn't permanently damaged. It helpful during preheating, but the particular LCD may malfunction on low temperatures.

Condensation Damage
After all, there can be a risk that this temperature data logger will be damaged by internal condensation when it's removed from the fridge. At some point, the device is usually pulled from the refrigerator to download this stored data. On nice days, leaving the cold data recorder about the table is like departing a glass of ice water for the table. If the dew point is greater than the temperature of the recorder being subtracted from the refrigerator, condensation happens. Everyone knows that h2o and electronics don't mixture well! We received several maintenance equipment which showed totally obvious signs of internal moisture damage caused by condensation. Even if the initial bug can be permanent, there is usually a potential problem, and experts recommend to do so.

I understand it is. 4 reasons fat loss put your temperature data logger within the fridge. This may seem like a task, but overall, it's a good idea to run the temperature data logger exterior the refrigerator and operate the probe inside. The only and most common method should be to pass the probe line through the door seal. Protection with small aluminum foil tape (for HEATING AND COOLING applications) prevents door put on.