Canon Printer Error Code P02 is frequently caused by a problem with the cartridges or an issue with the connectors on the printer. Printers, for example, make our tasks a lot easier and more efficient because they print at high speeds. Printers are rather straightforward to operate these days, thanks to the newest technological advancements and innovations that have made printers far more efficient and accessible. The Canon Firm, which you may be familiar with, is a Japanese multinational corporation that manufactures a wide range of products including printers, cameras, video cameras, photocopiers, steppers, and medical equipment. Located in the Tokyo neighborhood of Ota, the company's headquarters.

One of the most thorough solutions to the Canon Printer Error Code P02 has been created by a team of Canon Printer Support professionals. It is, as previously indicated, a problem with the cartridges themselves. However, it is not required to replace the ink cartridge; instead, take these methods to resolve Canon Printer Error Code P02 – Ink Cartridge Failure.

You can turn off your printer by clicking the power button on the control panel.
Turn it off for a few moments and come back on.
Once your Canon printer has been turned on, just transfer the cartridge from the right to the left.
As a result, check to see sure there is no foreign body present, such as a piece of paper or a paper clip, within the Printer's foreign particle. Follow the methods outlined below to properly clean your printer: –

Remove the printer's power cord and switch off the printer's power source.

Examine the area around the Rear Tray using a torchlight.
Remove any foreign objects that may be present with long-nose pliers with caution if they are there.
Also, look inside the printer to see if anything is wrong.
By opening the main access cover, you can turn on the printer.
As a result, the Print Head Holder will adjust its position to meet the new ink location.
Keep the printer's access lid open and the power cable disconnected at all times.
Slide the carriage to the right side of the printer until it comes to a complete stop.
Check the left and center areas for any obstructions with a torchlight to make sure there are none.
Remove any foreign objects that may be present with long-nose pliers with caution if they are there.
The carriage should be slid gently to the printer's small left side until it comes to a complete stop.
Examine the right side of the body with a torchlight to make sure there are no foreign objects.
Remove any foreign objects that may be present with long-nose pliers with caution if they are there.
Turn on the printer and check to see if it is fully functional.
After that, wipe the encoder strip with a dry, lint-free cloth to remove any remaining debris.
Finally, thoroughly inspect your printer to ensure that no components, such as carriage units, logic boards, or carriage motors, are damaged or malfunctioning.

If the actions indicated above are successful, you should be able to resolve the Canon Printer Error Code P02 in a short period of time. After attempting the steps indicated above and failing, you must contact the Canon Printer Support Help desk for more assistance.