If you are thinking about jewelry making equipment and supplies then this is the right place for you.
Jewelry making is an art which can be masted with years of practice and hard work. Though another important aspect of this is buying proper tools from jewelry manufacturing equipment.
Today we are going to talk about 12 tools that every jewellery equipment supplier must have.
• Pliers with a Flat Nose
These are going to be your go-to options. They'll assist you in opening jump rings, completing wire-wrapped ends, and a variety of other chores you've yet to envisage. You might want to have 2 sets so that you can grab anything without crimping the metal. Make sure the pliers' jaws have a smooth surface between them.
• Pliers with a Round Nose
These will assist you with the creation of wire hoops and loops, as well as bends, straps, and jump rings. Whenever you wish to make a lovely smooth curve, you'll reach for them.
• Pliers with a Nylon Tip
It takes practice to understand how to bend wire, and your material will inevitably kink. You can either blame the gods or grab a pair of nylon-tipped pliers. Simply take one end of the wire, tighten your hold with your pliers, and draw the wire through to smooth it out.
• Cutters for wires
These are what you want, and you want them to be of top quality. There are several low-cost options available, but they can soon wear out, particularly when cutting thicker wire.
• Disk Punch
Do you wish to cut circles, squares, or even hearts in a consistent and systematic way? Look no farther than a disc punch, a tool that produces similar forms every time.
Simply layer a sheet of metal between two layers, add the proper circle, and hammer out a disc with a disc punch. I've discovered that a brass hammer works best because it's hefty enough to provide a lot of extra strength while yet being soft enough to land a strong blow with little bounce back.
• Practice Material
You wouldn't want to spend a lot of money on gold or silver fill wire until you know what you're doing. Copper or other base metal wire will assist you in getting a handle on things without spending money.
• Ruler
A standard ruler is the most fundamental piece of jewellery equipment, and you probably already have one. I like a graph ruler since the ability to see beyond it helps in my visualisation.
• Saw for jewellers
If your ideas are tiny and need a lot of small, intricate cuts, a jeweler's saw is the way to go. Blades come in a variety of sizes, from thin blades that barely split the metal to strong, thick blades that remove more metal, allowing you to fine-tune the work of a piece.
• Tweezers
Tweezers are a must-have in every jewellery toolkit. They're not only suitable for managing hot designs, but they're also utilised to hold items while they're being soldered.
• Soldering Block
It's critical that your workplace is secure and that you have a good surface for soldering and working with heat. A soldering block is the ideal solution because it provides a fire-resistant surface that keeps the heat where you want it.
• Wire
Wire is available in a variety of materials and sizes, including sterling silver, gold-filled, rose gold, aluminium, and copper, to mention a few. The greater the gauge number, the narrower the wire, which may seem paradoxical. The 3 sizes you'll need in your jewellery tools are listed below.
• Gas Torch
A gas torch is a terrific place to start if you've never worked with a torch before. It can have a modest flame and can be used to solder small items.

Final Words:
You can find all the above tools from jewellery equipment supplier. With a good amount of practice and patience you will be able to master the art of jewellery making.