What are the inspection items before the construction of the water well drilling rig?

1. Check whether the air filter element of the Top Hammer Drilling Tools host is clean. The dust on the equipment should be removed. If it is too dirty, replace the filter paper.

2. Whether there is carbon deposit in the spark plug of the water well drilling rig. Whether the spark plug gap meets the working requirements, the carbon deposits in the spark plug hair should be removed and sorted out.

3. Check whether the pressure bottle of the water well drilling rig's water supply system is leaking, and whether the air pump system is leaking.

4. Whether the connecting rods, adapters, and O-rings on the drill pipe of the portable water well drilling rig are worn out. If the wear is severe, it should be replaced and oiled. Whether the connecting rod and drill rod are firm, if they are loose, tighten them.

5. Whether the starting rope of the water well drilling rig is firm, if it is found to be worn, it should be replaced in time.

6. The wear degree of the bottom of the diamond drill bit of the water well drilling rig, the wear of the drill bit's inner diameter, outer diameter, and lower lip surface exceeds the standard, and the hole is not allowed.

7. Whether the magneto of the gasoline engine of the water well drilling rig works normally, whether the positive and negative lines are conveyed normally, and whether the motor cooling fan works normally.

8. Whether the flushing fluid delivery pipe of the water well drilling rig is connected to the drilling rig and whether the pipeline is unblocked. Whether the delivery viscosity of the flushing fluid meets the drilling flow requirements of the mobile drilling rig.

9. Whether the connecting bolts between the main body of the water well drilling rig and the drilling rig are firm.

10. Whether DTH Drill Pipe repair tools are complete.