Leakage switch is generally used for socket circuit and toilet and kitchen circuit, of course other circuits can also be used. It is better to use the leakage when each branch is open after the main switch of the incoming Heavy Duty Slides Industrial line, which can avoid all the power failure in the home when some circuits have leakage.

2113 the electric box should be connected with a mechanical type, and the back 5261 side should be connected with air, and the leakage switch shall be connected on 1653 branch line 4102 which is wet and easy to be touched. Because of the low failure rate of mechanical type electric switch, the failure rate of air switch is relatively high, and the front gate is easy to repair and replace air switch. The branch line is connected with leakage switch to prevent leakage tripping of some circuits and affect the power supply of other lines.

Usually all sockets in the home should use two pole leakage protection switch. Lighting can use single pole non leakage switch. From a safety point of view, you should connect four single pole switches Sliding Drawer Box to the back of the leakage switch. Of course, if Kitchen Cabinet Hardware Suppliers one leakage is made, all the lines will not have electricity.

Yes.
There are two kinds of leakage closing:
1. Only leakage protection is available, without overload. When using electrical appliances such as socket, it is necessary to connect with air switch (overload protection) in series so that lighting power generally does not need leakage protection, and air switch can be used.
2. Leakage protector with both leakage protection and overload protection can be used in Socket line alone, and it is not necessary to use in series with air switch. The single pole air switch controls the lighting circuit.