Dell Phone number

Dell Error Code 2000-0125 is a Dell Enhanced Pre-Boot System Assessment (ePSA) error related to the Event Log. The Event Log gives information about the Basic input/output system (BIOS) and diagnostic events on your computer. The log acts as a basic resource for general usage and network traffic and does not necessarily indicate that there is an issue with your computer. If Dell Error Code 2000-0125 occurs often on your computer you can call the Dell tech support phone number and consult a trained technician to know more about what may have caused this error. You can also check out the troubleshooting steps mentioned in this article to see how you can fix this error.

Steps to Fix Dell ePSA Error Code 2000-0251
Step 1: Check and clear the Event Log: Review the event log in the BIOS and fix any pending issues that may be listed. Once the issues are fixed run a diagnostics scan to verify if there are any additional errors that were detected.
Step 2: Update to the Latest BIOS Version: Make sure you are using the latest System BIOS version available. Dell recommends that you always include a BIOS update in your scheduled update cycle so that your system is always compatible with other system modules including drivers and firmware. A BIOS update will also improve system security and ensure stable performance.
Step 3: Repeat the PSA Diagnostics: The Dell Pre-boot System Assessment diagnostics, or PSA as it is commonly known, helps you to select the correct test according to the error you are facing. You can follow the steps below to repeat the PSA Diagnostics
• Step 1: Switch off your Dell computer and check if it is connected to a docking device. If it is then you should unlock it and connect the computer to an electrical outlet.
• Step 2: Power up your computer and press F12 when you see the Dell logo. This will start the Dell Diagnostic process where the computer will run the Pre-boot System Assessment.
• Step 3: When the computer stops and beeps you know that there is a component failure. At this point, you should halt the PSA diagnostics and reboot the OS. Press ‘N’ to proceed with the next test and press ‘Y’ to retest the component that failed.
• Step 4: If you see that an error is detected during the PSA diagnostics make a note of it and call the customer care number to clarify the issue before proceeding.
If you find that the problem continues and that the event log still encounters an error you can call the Dell technical support phone number and ask for additional technical assistance. The helpline is active 24 hours a day and Dell experts will be able to give you a step-by-step guide on how to fix Dell Error Code 2000-0125 and prevent a similar error in the future.

Source URL: - http://www.facecool.com/profiles/blogs/how-to-fix-dell-error-code-2...