Summary:

This article introduces how to format the disk and where are the formatted disk data gone?

https://www.bitwar.net/data-recovery-software/
To format a hard drive means to delete any information on the drive and to set up a file system so your operating system can read data from, and write data to the drive. As complicated as that might sound, it is very common for Windows users. The time it takes to format a hard drive in Windows depends almost entirely on the drive's size, but your computer's overall speed plays a part, too.

Important: If the hard drive you want to format has never been used, or was just wiped clean, it must first be partitioned.

Any existing files on the drive would be erased with disk formatting. Disk formatting is usually done before the initial installation or before the installation of a new operating system. If the disk needs to be formatted, often you'll face the following things:

Incompatible file system error

To clean install Windows OS on a hard drive

Hard drive corrupted, developed bad sectors, access denied due to the RAW file system

If there is a requirement for additional storage in the computer

Disk formatting can be performed on both magnetic platter hard drives and solid-state drives. The formatting comprises low-level formatting and high-level formatting. Low-level formatting aids in preparing the physical structure on the storage media. High-level formatting helps in creating the file system format within the logical volume or the disk partition. Both formatting solutions will erase hard drive data, so make sure that you have backed-up all important data.
How to Format Hard Drive from Command Prompt?

To format a hard drive using cmd via Command Prompt, use the disk part commands given below carefully. Try your best to avoid mistakes.

Step 1. In your Windows, type cmd in the search box, you can get the best match called Command Prompt. Right-click on it and choose Run as administrator.

Step 2. On the Command Prompt black window, type diskpart and press enter.

Step 3. Now type list disk and press enter. All the disk drives will be listed, including your external drives that connected to the computer.

Step 4. Refer to the list disk information, type select disk + disk number, for example, select disk 1 and press enter. You're telling diskpart to format disk 1.

Step 5. Go on to type clean. This step starts to clean up all files and folders on the selected hard disk.

Step 6. Type create partition primary and press enter.

Step 7. After diskpart successfully created the specified partition, type format fs=ntfs (or format fs=exfat) and press enter. You're telling diskpart to format the drive with a file system, let it be NTFS, exFAT, etc.

Read more? You can go to the URL: https://www.bitwar.net/1402.html