icq sound download

Name: icq sound download
Category: Download
Published: taicomnanobs1981
Language: English

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The Radio Information Board.
Your source for radio information.
Unanswered topics Active topics Search The team.
Vertex VX-3200 programming problem.
Vertex VX-3200 programming problem.
Post by firemedic503 » Sat Jan 28, 2006 9:55 pm.
I was programming my VX-3200VC, when I went to download the radio it stopped at block 3 out of 168 and then it cleared the download window. Now it shows error 2 when I turn it on. I programmed another 3200 and it downloaded fine. Any suggestions?
Post by RadioTweester » Sun Jan 29, 2006 10:28 pm.
I don't remember if that error refers to a cable or a programming error, but by your description I'm guessing it's programming.
Try downloading the "default file" from the software into the radio [File] --> [Open] --> default.C52. --> [Open]. After you write/download it into te radio read/upload the radio into the software.
Make sure to let the radio go through it's selftest power-up in between the then download and upload. Save the upload file under a different name. Then edit the file with your freqs tones etc and try downloading it to that radio again. You can also try downloading your orignal file at this time and see if the radio will take it (alot of the time they will). If you're using an option board you might want to remove them until you can get the error code to clears. Then upload and download once you reinstall the board.
Let me know if that doesn't work. -Tom.
Post by firemedic503 » Sun Jan 29, 2006 11:15 pm.
Thanks for the reply.
I tried all of that and it still only runs to block 3 out of 168. One problem is everytime I turn it off and on it shows the error_2. It trys the self-test but goes right to the error_2 code. I did program another VX-3200 with no problems with the same software and cable.
Still can't figure this out.
Post by RadioTweester » Mon Jan 30, 2006 12:44 pm.
Hmmm. Are you using a conventional or an LTR 3200? Maybe you're trying to load a conventional template into an LTR radio. How old was the radio that you said you were able to program? Are you using the Windows or DOS software?
On a totally seperate note I see the 503 in your screen name, are you also in OR?
Post by firemedic503 » Mon Jan 30, 2006 8:51 pm.
I have the conventional VX-3200, both radios are 3 years old. I have programmed both radios in the past with no problems. I have the software on a laptop and desktop and have used both of these as well with no problems. I was updating some frequencies on the one showing an error_2 when this happened. Have always used windows based software for this.
Also I'm from Indiana, the 503 is my unit number on the Fire Dept.

http://releplecos1987.eklablog.com/djvu-viewer-free-download-a17796...