ilivid download manager

Name: ilivid download manager
Category: Downloads
Published: sennenorso1985
Language: English

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Retevis Radio Frequency Programming.
If you are a new guy to contact radio and have no ideas about more advanced settings of walkie talkie . Please see the contents below — a quite comprehensive radio Frequency Programming operations.
I.System Requirements.
Operating System :Windows98, Windows Me, Windows XP, Windows Vista, Windows7, Windows8 Hard Disk Space: At least 50MB of available . The minimum memory: 64M.
II.Install the USB driver.
1.Find the USB drive which your radio suited .
2.Click to install, finish this part with successfully installation .
III. Software Operations.
Programming cable.
1.USB Programming cable – need to install the driver before they write frequency.
2.Serial port Programming cable does not need to install the driver，it can directly write.
3.If the USB driver has been installed successfully, the port will be at least 2 port.
Remove the cable, then one port will be disappeared, that is the correct port which we are find, then connect the cable and choose the correct port.
Computer terminal preparations.
1.Open the computer, run the computer operating system. 2.Install the write frequency software which has been downloaded well or Install it From the programming software CD 3. installed, and open the write frequency software programming interface.
Radio end preparations.
1.USB(or serial)Programming cable connect the computer end 2.The USB Programming cable pin is connected with one end of the walkie talkie programming interface 3.Ensure the walkie talkie under the condition of power, open it.
IV. Frequency Programming.
1. Find the software settings, open communication port, to ensure the communication port Option and computer connection port consistent (inconsistent will not read frequency) to solve the related problem. 2. In the menu to find reading frequency and click in the window that appears can reading frequency.
3. This process needs waitting for a while, after the completion of reading the progress bar shows the radio channels and frequencies that have been read into the current software. 4. Modify the radio channel and frequency data, and other functional parameter data. 5. Find the write frequency in the menu ,click the appeared window to confirm , complete the progress bare . 6. if multiple radio needs the same frequency, frequency steps can be repeated to write.
V:Related problem solving.
When reading or writing frequency of radio long time no response or a communication error?
1.check the write frequency line to find if it is damaged. 2.check wether the write frequency line with computer serial port or radio interface is bad or loose. 3.Check to find whether the radio battery is low or out of power , if this ,please replace the battery or charging the battery . 4.Check whether the programming software is match with the current model . 5.Please check whether the write frequency software port settings are assigned to the computer USB port . 6.Please check whether the power is switched on the radio . 7.Whether to choose the corresponding drive system and the correct installation.
When writing the frequency is completed, found two radio cannot normal call or receive.
1.Make sure whether the two walkie-talkie are in the same channel . 2.Determine the same channel at the receiving end CTCSS, CDS and the transmitter is not the same . 3. make sure whether the two radio ‘ volume is too low, if it is too low ,Turn on the volume . 4. Please check whether the two walkie-talkies are open, or at low/no power status . 5. Check wether The walkie-talkie installed antenna . 6. check and confirm wether the communication distance is too far .

http://folsigade1988.eklablog.com/aarakshan-2011-songs-free-downloa...