But also prepare a few small pieces, as the floor and the wall to stay in the benchmark. Leaving the seam is hot for the floor cold shrinkage point of space, usually 1 cm or so, my family is 8 mm thick piece of composite flooring to do the benchmark, the seam is 8 mm, but just after the New Year shop, after 40 degrees Of the summer test, the problem did not occur from the arch, very good. Not only between the floor and the wall to stay seam, the floor and lay a good cabinet also have a direct seam, the location of the room door to stay a seam.WPC outdoor deck

The laying of the whole room starts from one side of the room and gradually approaches the other side. First board edge of the tank evenly cast glue (usually the tip of the plastic tip of the tip of the tip of the oblique cut, easy to wipe the plastic), and then the other board aligned slot, install. Then with a dedicated box against the outside side, with a hammer to click about the box, so close between the board, after they are good neighbors!WPC outdoor patio flooring

The middle of the room floor is the best shop, the edge and the corner is the most difficult, to measure the size, cut a good board, carefully inserted into the back with a needle-like large iron buckle buckle side, Then knock. Encounter turn and door, even more trouble. In view of this is not a composite floor laying textbooks, do not elaborate, anyway, master will help you get. My house there is less than a square where the door, it took the master 2 hours, and the study is also about so much time.teak boat decking