One problem that many people (including some engineers) face when encountering a faulty Hotpoint washing machine is to know the meaning of the error code, so here is a list of error codes and the meaning of the Hotpoint washing machine

These error codes may sometimes have an E in front of the number instead of F, as shown in the figure, but the meaning of the code is still the same

# F10-This means there is no cold filling. You should check and verify that the faucet is open or the hose is kinked.

# F11-This means there is no hot filling. The ambient temperature may be lower than the freezing point, possibly due to icing of the pipes. Also verify that the faucet is open or the drain hose is kinked.

# F12-This means there is no mixed filling. Usually the water under the faucet of the sink is probably not turned on.

# F13-For this error code, you should check the water supply, the water inlet control device, and the hot and cold hose connections.

# F14-A This error code indicates that there is a problem with the water heating system. You need to make an appointment for washing machine repair

# F15-The water has not been pumped away, and flooding may occur. Make sure that the discharge hose is raised to the minimum recommended height and the pipe is not blocked.

# F16-The water level is very high. Disconnect or turn off the water supply to ensure that the water level does not rise again. Then you need to find and make an appointment with a washing machine repair engineer

# F17-The door is not closed properly. Close the door tightly, and the machine should now be able to work normally. If just closing the door does not solve the problem, you need to find and make an appointment with a washing machine maintenance engineer.

# F20/1-The actual thermistor has drifted or the temperature scan sequence is incorrect. The ambient temperature may be below freezing point. You need to make an appointment with a washing machine maintenance engineer.

# F30/31-A motor drive problem has occurred. Try to run the program again. If the problem persists, please make an appointment with a service engineer.

# F40-The water is below the protection level during the heating step. You need to make an appointment for washing machine repair.

# F41-The water level detection sequence is incorrect. You need to make an appointment for washing machine repair.

# F50/51-Need to reprogram, customer language and washing program have not been saved. The system will run under default conditions (maximum 1000rpm and English). Book a washing machine repair to reprogram your product.

If you are looking for the best washing machine repairs in UK, then please visit https://ukwashingmachinerepair.co.uk